Daniel De La Garza
- Total activity 91
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Activity overview
Latest activity by Daniel De La Garza-
Daniel De La Garza created an article,
Wall Stationing: How to Station Off Existing Walls
Wall Stationing lets you station the laser tracker by holding the reflector against walls that already exist on site, so you can print without surveyed control points. Scan three or more points on ...
-
Daniel De La Garza created an article,
Use Corner Control Jigs to Station Off Existing Walls
Corner control is one of Dusty's Flexible Control capabilities. With corner control, you can station off the walls that are already there. This helps you in situations including: TI and renovation ...
-
Daniel De La Garza created an article,
How Do I Order More Ink for My FieldPrinter?
Order more ink for your FieldPrinter from the Dusty Ink Shop at shop.dustyrobotics.com. You can also open the shop from the Dusty Portal. Ink must come from the Ink Shop. Don't buy cartridges from ...
-
Daniel De La Garza created an article,
How Small and How Large a Circle Can the FieldPrinter Print?
Minimum circle diameterThere is no minimum. A circle with a diameter of zero prints as a dot, so a circle in your file can be as small as a single printed point.Maximum circle diameterThere is no f...
-
Daniel De La Garza created an article,
How to Insert the Reflector Into the FieldPrinter Mount
Lower the reflector straight down onto the robot's reflector mount until it drops into the notch and sits flat. Do this every time you put the reflector on the robot.A reflector that is tilted or o...
-
Daniel De La Garza created an article,
How Long Does It Take the Robot to Measure Area Elevation?
The time depends almost entirely on the grid size you choose. For a 10,000 sq ft floor, Area Elevation takes about 35 minutes at a 3' × 3' grid and about 5 hours at a 4" × 4" grid, with the FieldPr...
-
Daniel De La Garza created an article,
How to Use the Measure Tool in the Dusty App
Before You Start Open your layout in the Dusty app. You can measure before or after stationing; the tool reads the file, not the robot. Zoom so both points you want to measure are on screen. While ...
-
Daniel De La Garza created an article,
Why Are My Control Point Errors Different Later in the Day?
Control point errors change during the day because something has moved since you last stationed. Most often it's the laser tracker. A bump, vibration from nearby work, a loose tripod leg, or materi...
-
Daniel De La Garza created an article,
Laser Tracker Rubber Lens Hood: What It Does and Why It Matters
The black rubber lens hood on the front of the Laser Tracker keeps dust off the lens and keeps sunlight out of the tracker's internal optics. It fits around the lens where the laser beam leaves the...
-
Daniel De La Garza created an article,
How to Create a Control Point From Any Two Non-Parallel Lines
You can create a control point in the Dusty app from any two lines that are not parallel, even if they don't touch each other. Select the two lines and choose Create Control at Intersection. The ap...