Kafe Hezam
- Total activity 19
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by Kafe Hezam-
How to Select Control Points for Better Stationing Accuracy
OverviewChoosing the right control points significantly impacts the accuracy of your layout. This article covers four key principles for selecting and recording control points to maximize stationin...
-
Robot Stops Unexpectedly on Reflective, Glossy, or Wet Floors
OverviewIf the FieldPrinter stops and no physical obstacle is present, the floor surface itself may be triggering the robot's obstacle detection sensors. This is expected behavior.SymptomsThe Field...
-
Tracker Radio Issue Detected: How to Reset
OverviewIf you see the message "Tracker radio issue detected. Please reset the radio. If the issue persists, please try changing the radio and FieldPrinter to a new channel," this article explains ...
-
iPad Battery Draining Faster Than Expected
What You're Seeing The iPad battery is draining faster than expected during a print session. A fully charged iPad may reach 30% or lower after approximately 4 hours of use. Why This Happens ...
-
Wavy or Non-Overlapping Print Lines
What You're SeeingPrint lines are appearing wavy, misaligned, or non-overlapping. The issue may not be present at the start of a print session but can develop progressively over time. Both print h...
-
Tracker Shaking or Vibrating When Attempting to Re-Lock
What You're SeeingThe Laser Tracker is observed shaking or vibrating when the line of sight is lost, and a re-lock is being attempted. This behavior is most commonly reported at close range — typi...
-
"Tracker May Be Tilted" or "Elevations Do Not Match File Data" Error
What You're SeeingOne or both of these messages are being displayed on the iPad:"The tracker may be tilted""Recorded elevations do not match the file data"Printing may still be attempted, but accu...
-
Why Did My FieldPrinter Print Two Shifted Lines?
What HappenedIf your FieldPrinter printed two lines that appear slightly offset or shifted from each other, with a gap of roughly 0.5 inch or more between them, this is most likely caused by the ro...
-
Why Manual Obstacle Zoning Causes Overestimated Values Assigned to Objects and Time Left Fields?
OverviewDuring printing, the Dusty App displays an object count and an estimated time remaining. These values are intended to help operators track progress and plan accordingly. However, when obsta...