K.H
- Total activity 30
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by K.H-
Why is my robot detecting obstacles that aren't there?
OverviewIf your robot keeps flagging obstacles that aren't there, especially in dim or dark conditions, or on reflective floor surfaces, this article explains what's happening and how to fix it usi...
-
FATAL ERROR: Unhandled e0434352h Exception at fd099e5dh
IssueWhen using certain commands (hatch, copy/paste, save) in AutoCAD products, the following error appears, and AutoCAD closes: AutoCAD Error AbortingFATAL ERROR: Unhandled e0434352h Exception at ...
-
Printer Not Depositing Ink
If one or both sides of the FieldPrinter stop depositing ink, either immediately or after printing for a short time, work through the steps below in order before initiating a swap.SymptomsPrinter d...
-
How to Select Control Points for Better Stationing Accuracy
OverviewChoosing the right control points significantly impacts the accuracy of your layout. This article covers three key principles for selecting and recording control points to maximize stationi...
-
Robot Stops Unexpectedly on Reflective, Glossy, or Wet Floors
OverviewIf the FieldPrinter stops and no physical obstacle is present, the floor surface itself may be triggering the robot's obstacle detection sensors. This is expected behavior.SymptomsThe Field...
-
Tracker Radio Issue Detected: How to Reset
OverviewIf you see the message "Tracker radio issue detected. Please reset the radio. If the issue persists, please try changing the radio and FieldPrinter to a new channel," this article explains ...
-
iPad Battery Draining Faster Than Expected
What You're Seeing The iPad battery is draining faster than expected during a print session. A fully charged iPad may reach 30% or lower after approximately 4 hours of use. Why This Happens ...
-
Wavy or Non-Overlapping Print Lines
What You're SeeingPrint lines are appearing wavy, misaligned, or non-overlapping. The issue may not be present at the start of a print session but can develop progressively over time. Both print h...
-
Tracker Shaking or Vibrating When Attempting to Re-Lock
What You're SeeingThe Laser Tracker is observed shaking or vibrating when the line of sight is lost, and a re-lock is being attempted. This behavior is most commonly reported at close range — typi...
-
"Tracker May Be Tilted" or "Elevations Do Not Match File Data" Error
What You're SeeingOne or both of these messages are being displayed on the iPad:"The tracker may be tilted""Recorded elevations do not match the file data"Printing may still be attempted, but accu...