K.H
- Total activity 36
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by K.H-
Robot Stops Unexpectedly on Reflective, Glossy, or Wet Floors
If the FieldPrinter stops and no physical obstacle is present, the floor surface itself may be triggering the robot's obstacle detection sensors. This is expected behavior.Symptoms The FieldPrinter...
-
Tracker Radio Issue Detected: How to Reset
If you see the message "Tracker radio issue detected. Please reset the radio. If the issue persists, please try changing the radio and FieldPrinter to a new channel," this article explains what to ...
-
iPad Battery Draining Faster Than Expected
What You're Seeing The iPad battery is draining faster than expected during a print session. A fully charged iPad may reach 30% or lower after approximately 4 hours of use. Why This Happens ...
-
Wavy or Non-Overlapping Print Lines
What You're SeeingPrint lines are appearing wavy, misaligned, or non-overlapping. The issue may not be present at the start of a print session but can develop progressively over time. Both print h...
-
Tracker Shaking or Vibrating When Attempting to Re-Lock
What You're SeeingThe Laser Tracker is observed shaking or vibrating when the line of sight is lost, and a re-lock is being attempted. This behavior is most commonly reported at close range — typi...
-
"Tracker May Be Tilted" or "Elevations Do Not Match File Data" Error
What You're SeeingOne or both of these messages are being displayed on the iPad:"The tracker may be tilted""Recorded elevations do not match the file data"Printing may still be attempted, but accu...
-
Why Did My FieldPrinter Print the Same Line in a Different Place?
If a line is printed twice, as part of two different laser tracker placements, and the two lines don’t match, there are two possible groups of causes: Stationing Issues and FieldPrinter Issues. S...
-
Why Manual Obstacle Zoning Causes Overestimated Values Assigned to Objects and Time Left Fields?
OverviewDuring printing, the Dusty App displays an object count and an estimated time remaining. These values are intended to help operators track progress and plan accordingly. However, when obsta...
-
Why the iPad Says “Printed Successfully” But No Ink Appears
You may see the FieldPrinter complete a print and report success, but no visible ink appears on the floor. This can be confusing in the field.This behavior is expected in certain situations. The ro...
-
How to Update the Dusty App and FieldPrinter Software Version
To ensure full compatibility and access to new features, both the iPad and FieldPrinter must be updated to the latest version. When the iPad shows New Update Available, tap Update Now, finish th...