Overview

This checklist helps ensure the jobsite, equipment, and files are ready before deploying the FieldPrinter. Completing these checks reduces setup delays, prevents avoidable errors, and supports safe, efficient layout operations.

Use this checklist before stationing and printing on any jobsite.

Floor and Site Conditions

Confirm the printing area is suitable for robot operation:

• Surface is walkable and stable with no soft spots or hazards
• Printing area is clear of debris, dust piles, standing water, and loose materials
• Navigation paths are unobstructed, including pallets, cords, trash, or stacked material

Control Points

Confirm control is available and usable:

• At least three control points are accessible (six or more preferred)
• Control marks are visible and not covered by dust, paint, or protection board
• Control points are not blocked by materials, equipment, or temporary structures

Tracker and Tripod Setup

Confirm the tracker setup is stable and unobstructed:

• Tripod is placed on a stable surface
• Tracker is leveled to the center of the bubble
• No vibration from nearby tools, equipment, or foot traffic
• Clear line of sight to all required control points
• Radio is connected and powered

FieldPrinter and Tablet Preparation

Confirm the robot and tablet are ready:

• Tablet is charged and the Dusty App is up to date
• FieldPrinter is powered on and connected to the Dusty App
• Hotspot or Wi-Fi is available if updates or Portal sync are needed
• Ink cartridges are installed and cartridge faces are clean
• Batteries are charged and backup batteries are available

Jobsite Coordination

Confirm the work area is coordinated and safe:

• Active work in the printing area is paused or rerouted
• Nearby trades are informed that automated layout is underway
• Clear boundaries are set in the Dusty App if needed
• Printing area is protected from overhead work or lifts

Print File Readiness (Portal)

Confirm the layout file is ready for use:

• Layers and line styles are configured correctly
• Correct project, building, and level are selected on the tablet

Stationing and Verification

Confirm stationing is complete and reviewed:

• Reflector is placed correctly on each control point
• All error values are reviewed and within acceptable limits
• Verification point is checked, if required
• No unexpected warnings appear on the Station tab

Final Safety Check

Confirm the area is safe before printing:

• Trip hazards are cleared from the work area
• Robot path is reviewed for edges, drop-offs, or obstructions
• Operator has full visibility of the robot during printing
• Exits and walkways remain clear of stored materials